Icom IC-2300H Instruction Manual - Page 24

REPEATER OPERATION 4 ■ Reversed Duplex function When the reversed duplex function is ON, the receive frequency shifts. (The transmit frequency shifts in normal duplex mode.) An example receive and transmit frequency is shown in the table below with the following settings: Input frequency : 145.30 MHz Offset direction : - (Negative) Offset frequency : 0.6 MHz Reversed Rx frequency Tx frequency OFF 145.30 MHz 144.70 MHz ON 144.70 MHz 145.30 MHz q Push [SET] to enter the Set mode. w Push [SET] or [MONI] one or more times until "REV" appears. e Rotate [DIAL] to turn the reversed duplex mode ON or OFF. r Push any key other than [SET] or [MONI], to save the selection and exit the Set mode. Using the HM-133V z Push [set] to enter the Set mode. x Push [set] or [ent] until "REV" appears. c Push [Y] or [Z] to turn the reversed duplex mode ON or OFF. v Push [clr] to save the selection and exit the Set mode. 00 MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz The reversed duplex mode: OFF The reversed duplex mode: ON MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz The duplex icon blinks while the Reversed Duplex function is turned ON. MUTE NAR Push MID LOW LOCK to enter the Set mode. SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz 1 2 3 4 5 6 7 8 9 10 11 12 13 ■ Auto repeater (Only USA versions) The USA version automatically activates the repeater settings (DUP- or DUP+ and tone encoder ON/OFF), when the operating frequency falls within the general repeater output frequency range, and deactivates them when outside of the range. DDSetting the Auto Repeater function ON/OFF q Push [ ] to turn OFF power. w While holding down [LOCK] (SET), hold down [ ] to turn ON the power and enter the Initial Set mode. e Push [SET] until "RPT" appears as shown below. r Rotate [DIAL] to turn the Auto Repeater function to "R1," "R2" or "OF." • "OF": Auto repeater is OFF. • "R1": Auto repeater is ON, tone encoder is OFF. • "R2": Auto repeater is ON, tone encoder is ON. t Push [ ] to exit the Initial Set mode. MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz Auto repeater function is turned OFF. MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz Auto repeater function is ON, tone encoder is ON. DDFrequency range and offset direction Frequency range Duplex direction 145.200-145.495 MHz 146.610-146.995 MHz "-" appears 147.000-147.395 MHz "+" appears 16