Icom ID-52A Advanced Manual english - Page 228

14 SHARE PICTURES FUNCTION Sending the picture DDMoving the TX block marker You can select the block to start sending. LLWhile sending a picture, you cannot move the TX block marker. 1. Push D-pad() to select the TX Picture zone, and then push [ENT]. 2. Push [QUICK]. 3. Select "TX Picture Block Select." DDTX PICTURE SET This screen is used to set a picture, size, quality, and its intended destination to send. LLWhile sending a picture, you cannot change the settings. 1. Push D-pad() to select the TX Picture zone, and then push [ENT]. 2. Push [ENT] again. 3. Select the setting item. 4. Rotate [DIAL] or push D-pad to move the TX block marker. 4. Select an option. LLTo move the TX block marker back to 1st block, push [QUICK], and then select "BACK TO 1ST." 5. Push [ENT]. 6. To close the TX PICTURE screen, push [MENU]. 5. To close the TX PICTURE SET screen, push [MENU]. TIP: You can set each item to its default by pushing [QUICK], and then selecting "Default" on the Quick Menu window. TX Picture Select the picture to send, saved in the "Picture" folder ("ID-52" > "Picture") on the microSD card. LLWhen you set the TX Picture in the TX PICT HISTORY screen, "(RE TX)" is displayed before the file name. Picture Size (Default: 320 x 240) Set the desired size of a picture to send to "160 x 120," "320 x 240," or "640 x 480." LLYou cannot select a size larger than the size of the picture. Picture Quality (Default: Standard (50%)) Set the quality of a picture to send to "Low (25%)," "Standard (50%)," or "High (75%)." Receiver (Default: -----) Enter the receiver's call sign to let all stations that receive the picture know the picture's intended destination. NOTE: All stations that receive the signal can see the picture, even if they are not set as the receiver. 14-6