Intel SR1630HGP Service Guide - Page 66
Installing and Removing a Hard Drive (SR1630GP), Installing a Hard Disk Drive (SR1630GP)
![]() |
UPC - 735858211901
View all Intel SR1630HGP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
6. Reinstall and reconnect any parts you removed or disconnected to reach the processor sockets. 7. Install the server system cover. For instructions, see "Installing the Server System Cover". Installing and Removing a Hard Drive (SR1630GP) Caution: The hard drives are NOT hot-swappable. Before removing or replacing a hard drive, you must first take the server out of service, turn off all peripheral devices connected to the system, turn off the system by pressing the power button, and unplug the AC power cord from the system or wall outlet. You can install up to two SATA drives. The HDD0 drive bay is at the left side of the chassis, underneath the optional CD-ROM drive. The HDD1 drive bay is at the right side of the chassis. You do not need to install the drives in order; you can install HDD1 before HDD0. Note: The server system does not support all hard drives. See "Server System References" on page x for an Internet link to a list of supported hardware. Installing a Hard Disk Drive (SR1630GP) Note: If you are replacing a hard drive, see "Removing a Hard Disk Drive (SR1630GP)" on page 48 for instructions first. Return to these steps when directed. 1. Observe the safety and ESD precautions at the beginning of this book. See "Safety Information" on page iii. 2. Power down the server. Unplug all peripheral devices and the AC power cable. 3. Remove the server system cover. For instructions, see "Removing the Server System Cover" on page 30. 4. Locate the drive position you want to use. See Figure 31. 44 Intel® Server System SR1630GP / SR1630HGP Service Guide
![](/manual_guide/products/intel-sr1630gp-service-guide-75d595d/66.png)