Intel SR1630HGP Service Guide - Page 88

5. Remove the screw at the rear of the riser assembly. See letter "A" in Figure 54. Save this screw. You will reinstall it later. 6. If a filler panel is installed over the opening at the rear of the riser assembly, lift it from the riser assembly. See letter "B" in Figure 54. Save the filler panel in case you later need to remove the add-in card. 7. Insert the add-in card into the socket in the riser assembly. Push the add-in card into place firmly until it seats in the riser card connector, but use caution so you do not twist or bend the card. See letter "C" in Figure 54. 8. Re-install the screw you removed in Step 5. See letter "A" in Figure 54. C A B Riser Assembly Supports one PCIe* card. AF003286 Figure 54. Installing an Add-In Card 9. Install the PCIe* Riser assembly into the server system. For instructions, see "Installing the PCIe* Riser Assembly" on page 62. 10. Install the server system cover. For instructions, see "Installing the Server System Cover". 11. Plug all peripheral devices and the AC power cable into the server. Removing a PCI Add-in Card 1. Observe the safety and ESD precautions at the beginning of this book. See "Safety Information" on page iii. 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the server system cover. For instructions, see "Removing the Server System Cover" on page 30. 4. Remove the PCIe* Riser assembly. For instructions, see "Removing the PCIe* Riser Assembly" on page 61. 66 Intel® Server System SR1630GP / SR1630HGP Service Guide