Intel SR1630HGP Service Guide - Page 73
Installing and Removing a Hot-Swap SATA Drive (SR1630HGP)
![]() |
UPC - 735858211901
View all Intel SR1630HGP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Installing and Removing a Hot-Swap SATA Drive (SR1630HGP) You can install up to three hot swappable SATA drives. The HDD0 drive bay is at the left side of the chassis; the HDD1 drive bay is in the middle of the chassis-underneath the optional optical drive. The HDD2 drive bay is at the right side of the chassis. You do not need to install the drives in order; you can install HDD1 before HDD0. Cautions: If you install less than three drives or devices, the empty drive bays must be occupied by carriers with baffles to maintain proper system cooling. Note: The server system does not support all hard drives. See "Server System References" on page x for an Internet link to a list of supported hardware. Installing a Hot-Swap SATA Drive (SR1630HGP) 1. If it is installed, remove the front bezel. For instructions, see "Removing the Front Bezel". 2. Locate the drive position you want to use. See Figure 37. HDD 0 HDD 1 HDD 2 AF003255 Figure 37. Locating Drive Positions (SR1630HGP) Intel® Server System SR1630GP / SR1630HGP Service Guide 51
![](/manual_guide/products/intel-sr1630gp-service-guide-75d595d/73.png)