Kenmore 1317 Installation Instructions - Page 10
bo,,eeC,t ,7
UPC - 883049058658
View all Kenmore 1317 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Remove two screws attaching access panel and lower panel to dishwasher using a 1/4" hex socket, nut driver or Phillips screwdriver. 3. Remove panels and set panels aside on a protective surface. 4. Check that grounding clip is attached to the lower panel. lower panel clip ApplyTeflon _: tape or pipe joint compound to 90 ° elbow fitting and connect fitting to water inlet valve. water inlet valve I Tighten elbow until snug, and be sure that it faces to the rear. 7. Remove terminal box cover. - If you are direct wiring: install a UL listed/CSA certified clamp connector to the terminal box. If using conduit, use a UL listed/CSA certified conduit connector. - If you are installing a power supply cord kit, do so now, following kit instructions. _, _J_ [;erxm_naler Turn both front leveler legs to the same height. If the minimum cutout height is less than 34" (86.4 cm), the rear wheels can be removed for additional clearance.This will allow the dishwasher to fit into a 33-7/8" (86 cm) high cutout, but the dishwasher will be more difficult to move into position. If the wheels are removed, protect when moving the dishwasher. front leg the floor if you have built-up floors /countertop Measure height of opening from underside of countertop to built-up floor. If the height is at least 33-3/4" (85.7 cm), the dishwasher will fit into the opening without modification to the countertop or flooring. shim _/ 33-3/4" (85.7 cm) min. 2. Put wheels in position 1 and turn the front leveler legs up all the way. 3. Add shims as needed in the area shown to bring dishwasher up to proper height. NOTE: Shims prevent their operated. must be securely movement when attached to floor to the dishwasher is shim 2" (5.1 cm) (7.0cm) 6" (15.2 cm) (ZOcm) / dishwasher wires ;bo,,eeC,t ,7 HelpfulTip: Put cardboard under dishwasher until it is installed in cabinet opening.The cardboard will help protect floor covering during installation. Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed (you need the lowest point). Check chart for that height opening. Put wheels in the required position. wheel Minimum cutout height 34" (86.4 cm) 34-1/4" (87 cm) 34-1/2" (8_6 cm) Wheel position 1 2 3 Number of turns on front leg 10 5 0 10 Install custom door panel kit (on some models) If installing a custom door panel kit, install it now following instructions included with kit.