Kenwood MDX-F1 User Manual - Page 29

Pause the recording MD 0 6 ÷ The track number is incremented by "1". Press the key again to resume recording. ÷ Recording can also be started by pressing the "MD REC" key. Stop the recording STOP 0 7 In regard to track numbers at the time of recording When a part without sound continues for 2 sec. or more during recording, the track number is automatically increased by "1" when the next sound enters. When classic music continues with low sound, the track number may be increased by "1". (The track number is not increased during recording of the tape or tuner input.) The erroneously set track number can be erased later. When it is desired to increase the track No. during recording, press the TRACK EDIT key during recording to record a track No. at that position. The track numbers are used at the time of playback to find the start of tracks, for programming, etc. Press during recording. TRACK EDIT ÷ With digital recording from a CD, the track number is increased when the track changes. Contents Let's recording 29 MDX-F1 (EN) Lights REC 0 1 TRACK NO. 130 001 R54:32 The recordable time for the MD is displayed. The "WRITING" display indicates that the recorded and edited data are written in the MD. Be careful not to apply impact to the unit during it. If the power cord is unplugged before completion of "WRITING", the recorded and/or edited data may be lost. At the time of recording from a CD, the track Note number may be incremented when CD playback starts. This occurs because of a signal included in the digital signal from the CD. Delete unwanted track numbers under reference to "TRACK ERASE or ALL ERASE". w Operation In regard to display messages Recording is not possible when one of the following messages is displayed. "DISC FULL" : The minidisc is full. \ Erase unrequired tracks. "PROTECTED" : The write protect tab is open. \ Close it. "PLAY ONLY" : The minidisc is only for playback. \ Insert a recordable disc. w p