Kenwood MDX-F1 User Manual - Page 55
CD player Cassette deck
View all Kenwood MDX-F1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Contents CD player section Symptom Cause A CD is placed in the player but ÷ The disc is placed upside down. it cannot be played. ÷ The disc is extremely dirty. ÷ Dew is condensed on the optics lens. In case of difficulty 55 MDX-F1 (EN) Remedy ÷ Place the disc properly, with the label side facing upward. ÷ Clean the disc referring to "Disc handling precautions". ÷ Refer to "Caution on condensation" and remove the condensation by evaporation. p o Sound is not produced. ÷ The disc is extremely dirty. ÷ The disc is scratched. ÷ Clean the disc referring to "Disc han- dling precautions". p ÷ Try another disc. Sound skips. ÷ The disc is dirty. ÷ The player is subject to vibration. ÷ Clean the disc referring to "Disc handling precautions". ÷ Install the unit in a place not subject to vibrations. p Cassette deck Symptom Sound cannot be produced by pressing the play key. Cause ÷ The head is dirty. ÷ The tape is wound too tight due to irregular winding. ÷ A nonrecorded tape is played. Remedy ÷ Clean the head referring to "Cleaning the head section". i ÷ Try another tape. ÷ Play a recorded tape. No operation occurs even when an operation key is pressed. ÷ The cassette holder is not closed completely. ÷ The operation key is pressed in less than 4 seconds after turning the power ON. ÷ The tape is wound too tight due to irregular winding. ÷ Close the holder completely. ¢ ÷ Press operation keys after waiting for more than 4 seconds. ÷ Try another tape. The cassette holders cannot be opened by pressing the "0 push OPEN" button. ÷ The key is pressed during recording or playback. ÷ The microcomputer is malfunctioning due to external noise. ÷ Press in stop mode. ÷ Reset the microcomputer. W Sound is harsh or high fre- ÷ The head is dirty. quencies are not reproduced. ÷ The tape is stretched or shrunk. ÷ Clean the head referring to "Cleaning the head section". i ÷ Try another tape. Noise is noticeable. ÷ The tape head is magnetized. ÷ A tape recorded with Dolby NR ON is played with TAPE EQ. OFF. ÷ Demagnetize the head referring to "Cleaning the head section". i ÷ Set the TAPE EQ. to on. ∞ Recording cannot be started by pressing the record key. ÷ The recording protect tab of the cassette has been broken. ÷ The cassette holder is not closed completely. ÷ The TAPE input is selected. ÷ The tape is fully wound to one of the reels. ÷ Use a cassette with an unbroken record- ing protect tab or block the hole. Q ÷ Close the holder completely. ¢ ÷ Set the input selector to the source to be recorded. º ÷ Change the tape transport direction or reverse the tape insertion orientation. ¢ Knowledge section