Kenwood TM-281 Operation Manual - Page 10

PREPARATION 1 MOBILE INSTALLATION To install the transceiver, select a safe, convenient location inside your vehicle that minimizes danger to your passengers and yourself while the vehicle is in motion. Consider installing the unit at an appropriate position so that knees or legs will not strike it during sudden braking of your vehicle. Try to pick a well ventilated location that is shielded from direct sunlight. 2 Position the transceiver, then insert and tighten the supplied hexagon SEMS screws (4) and flat washers (4). • Double check that all hardware is tightened to prevent vehicle vibration from loosening the bracket or transceiver. 1 Install the mounting bracket in the vehicle using the supplied self-tapping screws (4), flat washers (4), and spring washers (4). • The bracket must be installed so that the 3 screw hole positions on the side of the mounting bracket are towards the rear of the bracket. Self-tapping screw (5 mm x 16 mm) Spring washer Flat washer SEMS screw • Determine the appropriate angle of the transceiver, using the 3 screw hole positions on the side of the mounting bracket. 2