Kenwood TM-281 Operation Manual - Page 53
SCAN RESUME METHOD, Time-Operated Mode default, Carrier-Operated Mode, Seek Mode, MENU], Tuning
View all Kenwood TM-281 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
SCAN RESUME METHOD The transceiver stops scanning at the frequency (or Memory Channel) where a signal is detected. It then continues or stops scanning according to which Resume Mode you have selected. • Time-Operated Mode (default) The transceiver remains on a busy frequency (or Memory Channel) for approximately 5 seconds, then continues to scan even if the signal is still present. • Carrier-Operated Mode The transceiver remains on a busy frequency (or Memory Channel) until the signal drops out. There is a 2-second delay between signal dropout and scan resumption. • Seek Mode The transceiver moves to a frequency (or Memory Channel) where a signal is present and stops. To change the scan resume method: 1 Press [F], [MENU] and turn the Tuning control to select Menu No. 13 (SCAN). 2 Press [MENU] and turn the Tuning control to select "TO" (Time-Operated; default), "CO" (CarrierOperated), or "SE" (Seek) Mode. 3 Press [MENU] to store the new setting or any other key to cancel. 4 Press any key other than [MENU] to exit Menu Mode. Note: To temporarily stop scanning and monitor weak signals, press the Mic PF key assigned the MONI function {page 59}. Press the MONI key again to resume scanning. 8 45