Kenwood TM-V71A Operation Manual - Page 52
Memory Scan
![]() |
View all Kenwood TM-V71A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
MEMORY SCAN Use Memory Scan to monitor all Memory channels programmed with frequency data. 1 Select your desired band. 2 Press [MR] (1s). • Scan starts at the current frequency. • The 1 MHz decimal blinks while scanning is in progress. • To reverse the scan direction, turn the Tuning control clockwise (upward scan) or counterclockwise (downward scan). You can also press microphone [UP]/ [DWN]. 3 To quit Memory Scan, press [MR] again. Note: ◆ At least 2 Memory channels must contain data and must not be locked out of scan. ◆ The L0/U0 to L9/U9 Memory channels will not be scanned. ◆ You can also start Memory Scan when in Channel Display mode. While Scan is paused on a channel, the channel number blinks. ■ Locking Out a Memory Channel You can select Memory channels that you prefer not to monitor while scanning. 1 Press [MR], then rotate the Tuning control to select your desired channel. 2 Enter Menu mode and access Menu 202 (L.OUT) {page 20}. 3 Set the lockout to ON to lock the channel out of the scanning sequence. • To cancel lockout, set the lockout to OFF. • The icon appears on the display for a channel that has been locked out. Note: The L0/U0 to L9/U9 Memory channels cannot be locked out. 44
![](/manual_guide/products/kenwood-tmv71a-operation-manual-c7a4adb/52.png)