Kenwood TM-V71A Operation Manual - Page 88
Playback, Playback Repeat, Playback Repeat Interval
![]() |
View all Kenwood TM-V71A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
■ Playback 1 Press the PF key programmed as [VGS]. • When preparing to transmit, press the [PTT] switch before pressing the channel number (1 - 3) key. 2 Press the key for the VGS channel number you want to play back: [F] (1), [TONE] (2), [REV] (3), or [LOW] (4) (when the Continuous Recording is ON.) • The recording saved in the channel you selected is played back. • To end playback at any time, press [PF1] (CLR). • To exit, press [VGS] again. • Playback signals are output from the PTT band side. Use the [BAND SEL] of the PTT band to adjust the speaker volume. • During playback, you can switch to any of recordings 1, 2, 3, or 4 by pressing the appropriate key. ■ Playback Repeat You can set messages to be repeatedly played back. 1 Enter Menu mode and access Menu 007 (PLAY.BK) {page 20}. 2 Set the the Playback Repeat function to ON or OFF. ■ Playback Repeat Interval If the Playback Repeat function is activated, you can set a time interval for how often the memo/message is played back. 1 Enter Menu mode and access Menu 008 (P.BK.INT) {page 20}. 2 Set the interval from 0 to 60 seconds. 80
![](/manual_guide/products/kenwood-tmv71a-operation-manual-c7a4adb/88.png)