Konica Minolta bizhub C360 bizhub C220/C280/C360 Copy Operations User Guide - Page 69
Basic], Finisher FS-527, Finisher FS-529, Job Separator JS-505, Settings
View all Konica Minolta bizhub C360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
5.1 [Basic] Settings [Offset] [Yes]/[No] 5 Specify whether to separate each set of copies from another set in the output tray when copying multiple sets of multi-page originals. When the Finisher FS-527, Finisher FS-529, or Job Separator JS-505 is not installed: If the following conditions are met, printed copies are fed out and sorted in an alternating crisscross pattern. • The 8-1/2e11, A4, or B5 size paper is used • Paper of the same size and type is loaded with the w orientation in one pa- per tray and with the v orientation in another tray • Auto paper selection is specified for the paper size setting When the Finisher FS-527, Finisher FS-529, or Job Separator JS-505 is installed: The copies are fed out and stacked on top of each other with each set shifted to separate it. [Fold/Bind] [Staple] Staples copy outputs in the center the paper or fold them in the center before discharging. [Half-Fold] [Center Staple & Fold] Staples copies in corner or at two points before they are output. [Punch] [Position Setting] Punches holes in copies before they are output. 1 1 1 Configure desired staple or hole-punch positions. Select Auto, and the machine automatically judges the staple or punch positions for the paper relative to the original direction loaded. • A staple or punch position along the long side of the paper is selected if the original length is 11-11/16 inches (297 mm) or less. • A staple or punch position along the short side of the paper is selected if the original length exceeds 11-11/16 inches (297 mm). • Staple or punching positions are set on the upper or left-side end. • Be sure to load the original so that its top side is placed in the back. • If desired, press [Original Direction], and then select the original direction. bizhub C360/C280/C220 5-12