Lantronix XPress-DR XPress-DR / XPress-DR-IAP - User Guide - Page 45
Serial Port Login, You have one second
View all Lantronix XPress-DR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Getting Started 2.6 Serial Port Login If you want to initially configure the unit through a serial connection, follow these steps: 1. Connect a console terminal or PC running a terminal emulation program to your unit's serial port. The default serial port settings are 9600 baud, 8 bits, no parity, 1 stop bit, no flow control. 2. To enter Setup Mode, cycle the unit's power (power off and back on). After power-up, the self-test begins and the red Diagnostic LED starts blinking. You have one second to enter three lowercase x characters. Note: The easiest way to enter Setup Mode is to hold down the x key at the terminal (or emulation) while powering up the unit. 3. At this point, the screen display is the same as when you use a Telnet connection. To continue with a serial port login, go to Using a Telnet Connection on page 3-10. DSTni-XPress DR User Guide 2-13