Lantronix XPress-DR XPress-DR / XPress-DR-IAP - User Guide - Page 66
Table 15 - Modem Mode Commands, Modem Mode, Command, Function
View all Lantronix XPress-DR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Configure Table 15 - Modem Mode Commands Modem Mode Command ATDTx.x.x.x,pppp or ATDTx.x.x.x/pppp ATDTx.x.x.x ATD0.0.0.0 ATD ATDx.x.x.x ATH ATS0=n ATEn ATVn Function Makes a connection to an IP address (x.x.x.x) and a remote port number (pppp). Makes a connection to an IP address (x.x.x.x) and the remote port number defined within the unit. Forces the unit into monitor mode if a remote IP address and port number are defined within the unit. Forces the unit into monitor mode if a remote IP address and port number are not defined within the unit. Makes a connection to an IP address (x.x.x.x) and the remote port number defined within the unit. Hangs up the connection (Entered as +++ATH ). Enables or disables connections from the network going to the serial port. n=0 disables the ability to make a connection from the network to the serial port. n=1-9 enables the ability to make a connection from the network to the serial port. n>1-9 is invalid. Enables or disables character echo and responses. n=0 disables character echo and responses. n=1 enables character echo and responses. Enables 1-character response or full verbose. n=0 enables 1-character response. n=1 enables full verbose. Note: These AT commands are only recognized as single commands like ATE0 or ATV1; compound commands such as ATE0V1 are not recognized. All other AT commands with Modem Mode set to full verbose acknowledge with an OK, but no action is taken. 3-20 DSTni-XPress DR User Guide