Lenovo S200 Hardware Maintenance Manual - Page 68
and/or
View all Lenovo S200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Diagnostic Error Code FRU/Action 006-197-XXX Diskette interface test warning 1. If a component is called out, make sure it is connected and/or enabled 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 006-198-XXX Diskette interface test aborted 1. If a component is called out, make sure it is connected and/or enabled 2. Flash the system and re-test. See "Flash update procedures" on page 243 3. Go to "Undetermined problems" on page 81 006-199-XXX 1. Go to "Undetermined problems" on page Diskette interface test failed, cause unknown 81 2. Flash the system and re-test 3. Replace component under function test 006-25X-XXX Diskette interface Error 1. Diskette drive cable 2. Diskette drive 3. System board 011-000-XXX Serial port Interface Test Passed No action 011-001-XXX Serial port Presence 1. Remove external serial device, if present 2. Run setup, enable port 3. System board 011-002-XXX 011-003-XXX Serial port Timeout/Parity error System board 011-013-XXX 011-014-XXX Serial port Control Signal/Loopback test failure System board 011-015-XXX Serial port External Loopback failure 1. Wrap plug 2. System board 011-027-XXX Serial port Configuration/Setup error 1. Run Setup, enable port 2. Flash the system. See "Flash update procedures" on page 243 3. System board 011-03X-XXX 011-04X-XXX Serial port failure System board 011-195-XXX Serial port Test aborted by user Information only Re-start the test, if necessary 011-196-XXX 1. Press F3 to review the log file Serial port test halt, error threshold exceeded 2. Re-start the test to reset the log file 62 Hardware Maintenance Manual