Motorola V3229 Operating Instructions - Page 184
Program Number, Command, Intermediate, Call Progress, Responses, DialStoredNumber
View all Motorola V3229 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
7 V.25 bis Autodialer Incoming ring detected. Program Number Command PRN a; nn...n The program number command is PRN followed by the one digit decimal address a and the number to be stored nn . . . n. Each address can store up to 32 dial parameters. Ignored characters in the dial number are not stored. Nine stored numbers are available at addresses 1-9. Responses: Same as for the CRN command. Intermediate Call Progress Responses The following responses are given only if enabled. Refer to the OPTIONS section later in this chapter. CNX@nnnnnBPSccccc - where nnnnn is the line speed and ccccc is an identifier with a maximum of five characters, such as V.29. This connect response appears after handshake completed, but before DSR is activated. This response is required if the intermediate call progress option is enabled. Dial Stored Number CRS a The command for dialing a stored number is CRS followed by the one digit address a for the stored number to be dialed. Responses: Same as for the CRN command plus V.3229 / V.3229L -7