Motorola V3229 Operating Instructions - Page 83

5 Asynchronous Operating Commands Terminal Interface Commands, Cont. Table 7: Switching to Answer Mode after Dialing R use an R at the end of the dial sequence. AT D 555- place a semicolon at the end of the dial 2345 R; string. AT D 234- use the @ command. 5678 ;@ AT D 3994700 @ 2251 ; after the connection waits for 5 seconds. The modem then sends service code 2251 and returns to command mode for further input. For example you might enter a dollar amount for a banking transaction by entering AT D 1400 ; according to the requirements of the banking service. Dialing a Stored Command Line Telephone S enter ATDSn where n represents a stored telephone number location between 1 and 9. AT D which is used for any autodial applica- S9*AUn tion. Voice Calls dial the number with the telephone. To use the dial command for the call AT D (num- place the modems at both ends in ber) ; DATA mode by pressing the TALK / DATA button. ANSWER- answer by pressing the TALK/ DATA ING A CALL button. AT Command An- swer AS0 the modem automatically answers on the selected ring and connects with the calling modem. Note: If the modem is set to respond to DTR the DTR signal must be on for autoanswer to work. Detect &C enter AT&C1. Some terminals and other devices require DCD on in order to communicate with the modem; if so V.3229 / V.3229L -19