Motorola V3229 Operating Instructions - Page 78
<C#>-14, V.3229 / V.3229L, Asynchronous Operating Commands, Response Messages
View all Motorola V3229 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
5 Asynchronous Operating Commands Dial Commands, Cont. Response number codes, messages, and their corresponding meanings are listed in Table 5-1. CONNECT messages may be selected for output to the DTE at the DTE or DCE rate. If register S39 bit 5 is set to 0, the CONNECT message is sent at the DTE rate; if 1, the message is sent at the DCE rate. Table 5-1 Response Messages Table 5: Code Message Meaning 0 OK Command received 1 CONNECT Connect at 300 bps while X1, X2, X3, or X4 command in effect; all rates while X command in effect 2 RING Ring detected 3 NO CARRIER Valid carrier is not detected after call attempt within period specified by register S7, or carrier lost for value of S10 or more 4 ERROR Command not recognized or too long 5 CONNECT 1200 Connection made at 1200 bps 6 NO DIAL TONE No dial tone detected for 5 seconds (X2 or X4 command in effect) 7 BUSY Dialed number busy (X3 or X4 command in effect) 9 CONNECT 7200 DTE rate 7200 bps 10 CONNECT 2400 DTE rate 2400 bps 11, 15 CONNECT 4800 DTE rate 4800 bps 12, 18 CONNECT 9600 DTE rate 9600 bps 13 CONNECT 12000 DTE rate 12000 bps 14 CONNECT 19200 DTE rate 19200 bps 16 CONNECT 38400 DTE rate 38400 bps 17 CONNECT 14400 DTE rate 14400 bps 19 CONNECT 57600 DTE rate 57600 bps 20 CONNECT 0300/REL MNP 300 bps connection -14 V.3229 / V.3229L