Motorola V3229 Operating Instructions - Page 75
V.3229 / V.3229L, <C#>-11, Asynchronous Operating Commands
View all Motorola V3229 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
5 Asynchronous Operating Commands Response Commands, CRonets.ponse messages may be sent to the DTE at the DTE rate or the current DCE rate. Refer to S39 in Chapter 6 for further information. Call Progress and Connect Speed Displays X The X command selects connect / message displays and dialing options such as call progress monitoring, busy signal or dial tone detection and blind dialing. Table 3: X Dial tone and busy signal detection not selected; CONNECT (code 1) re- sponse messages displayed for all speeds X1 Dial tone and busy signal detection not selected; appropriate CONNECT response messages or codes dis- played for data rate X2 Dial tone detection only; NO DIAL TONE message or code appears if dial tone not detected within 5 sec X3 Busy signal detection only; BUSY message or code appears if dialed number is busy X4 Dial tone and busy signal detection; appropriate CONNECT message or code displayed * *default X followed by a dial command causes the modem to go off hook, wait the amount of time set in register S6, and dial the number. If connection is made the modem returns a CONNECT (code 1) message to the screen regardless of the speed of connection. With a basic response, the modem will not detect a busy or no dial tone condition. V.3229 / V.3229L -11