Netgear GS108T-100NAS GS108T Setup Manual - Page 113
Patch Panels and Cables, C-1
View all Netgear GS108T-100NAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
GS108T Smart Switch Software Administration Manual Figure C-1 illustrates straight-through twisted pair cable. Figure C-1 Figure C-2 illustrates crossover twisted pair cable. Figure C-2 Patch Panels and Cables If you are using patch panels, make sure that they meet the 100BASE-TX requirements. Use Category 5 UTP cable for all patch cables and work area cables to ensure that your UTP patch cable rating meets or exceeds the distribution cable rating. To wire patch panels, you need two Category 5 UTP cables with an RJ-45 plug at each end, as shown in Figure C-3. Network Cabling C-3 v1.0, May 2007
GS108T Smart Switch Software Administration Manual
Network Cabling
C-3
v1.0, May 2007
Figure C-1
illustrates straight-through twisted pair cable.
Figure C-2
illustrates crossover twisted pair cable.
Patch Panels and Cables
If you are using patch panels, make sure that they meet the 100BASE-TX requirements. Use
Category 5 UTP cable for all patch cables and work area cables to ensure that your UTP patch
cable rating meets or exceeds the distribution cable rating.
To wire patch panels, you need two Category 5 UTP cables with an RJ-45 plug at each end, as
shown in
Figure C-3
.
Figure C-1
Figure C-2