Netgear WAC720 Reference Manual - Page 13
Hardware Requirements for Computers on Your LAN, Operating Frequency Guidelines
View all Netgear WAC720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730 Hardware Requirements for Computers on Your LAN To connect to the wireless access point on your network, an 802.11bg/ng/bgn or 802.11a/a-na-ac wireless adapter must be installed on each computer. We recommend using the wireless access point with computers with the NETGEAR A6210 WiFi USB Adapter installed. Operating Frequency Guidelines You do not need to change the operating frequency (channel) unless you notice interference problems or you place the wireless access point near another wireless access point. If you do change the operating frequency, observe the following guidelines: • Wireless access points use a fixed channel. You can select a channel that provides the least interference and best performance. In the United States and Canada, 11 channels are available. • If you use multiple wireless access points, it is better if adjacent wireless access points use different channels to reduce interference. The recommended channel spacing between adjacent wireless access points is five channels (for example, use Channels 1 and 6, or 6 and 11). • In infrastructure mode (which is the default mode for the wireless access point), wireless stations normally scan all channels, looking for a wireless access point. If more than one wireless access point can be used, the one with the strongest signal is used. This is possible only if the wireless access points use the same SSID. Requirements for Entering IP Addresses IP addresses assigned to the access points must follow the following requirements for IPv4 and IPv6 addresses. IPv4 The fourth octet of an IP address must be between 0 and 255 (both inclusive). This requirement applies to any IP address that you enter on the wireless access point's web management interface. IPv6 IPv6 addresses are denoted by eight groups of hexadecimal quartets that are separated by colons. Any four-digit group of zeroes within an IPv6 address can be reduced to a single zero or altogether omitted. The following errors invalidate an IPv6 address: • More than eight groups of hexadecimal quartets • More than four hexadecimal characters in a quartet • More than two colons in a row Initial Setup 13