Netgear XSM4324FS Software Setup Manual Software Version 12.x - Page 17

M4300 Intelligent Edge Series Fully Managed Stackable Switches Subnet Mask: 255.255.255.0 Default Router: 172.26.2.1 Do you want to assign IPv4 address manually? (Y/N/Q)? The IPv4 address will be assigned automatically by the DHCP server in your network. You can disable DHCP mode and use a static (fixed) IPv4 address. If fixed IPv4 address mode is selected, DHCP mode is disabled, and you are prompted to set the values for these fields. 9. To set up an IPv6 address for the OOB port (which is also referred to as the service port), type A to generate an IPv6 address automatically, or type D to get an IPv6 address from the DHCP server, or type C to add an IPv6 address to the OOB port. Service port IPv6 Address Mode: None IPv6 Administrative Mode: Enabled Service port IPv6 Address Mode autoconfigure: Disabled IPv6 Address: fe80::6eb0:ceff:fef9:f6e1/64 Network IPv6 address gateway: IPv6 Default Router: fe80::222:3fff:fe9e:9605 EUI Flag: True The IPv6 address has been assigned manually. What do you want to do? A - Assign IPv6 address for the switch using Auto Mode. D - Assign IPv6 address for the switch using DHCP Mode. G - Assign IPv6 Gateway. C - Add IPv6 address. N - Skip this option and go to the next question. Q - Quit. ? - Help. 10. To change the management interface, type O to select the OOB port (which is also referred to as the service port) as the source IP address of the management protocol such as syslog, SNMP client, and so on. Or type V to select the IP address of the management LAN as the source IP address of the management protocol. Current Management Interface Configuration Management Interface: L3 Management VLAN Current management interface is L3 Management VLAN. What do you want to do? Get Started 17 Software Setup Manual