Nikon COOLPIX P610 Reference Manual - Page 124

B Notes About Location Data Functions • Before using the location data functions, read " Notes About Location Data Functions (GPS/GLONASS)" (Axi). • It takes a few minutes to obtain location data when positioning is performed for the first time or in a situation where positioning cannot be performed for a long period of time, or just after the battery is replaced. Using the latest A-GPS file can shorten the time needed for obtaining the location data (E93). • Positions of the positioning satellites change constantly. You may not be able to determine the position or it may take some time depending on your location and the time. To use the location data functions, use the camera in an open-air area with few obstacles in the sky. Signal receiving will be smoother if the positioning antenna (A2) is facing the sky. • The following locations which block or reflect signals may result in failed or inaccurate positioning. - Inside buildings or underground locations - Between high-rise buildings - Under overpasses - Inside tunnels - Near high-voltage electrical power lines - Between clusters of trees • Using a mobile phone of 1.5 GHz band near this camera may disrupt positioning. • When carrying this camera around while positioning, do not place it in a metal bag. Positioning cannot be performed if the camera is covered with metal materials. • When there is a significant difference in the signals from the positioning satellites, there could be a deviation of up to several hundred meters. • Be aware of your surroundings when positioning. • The shooting date and time that is displayed when playing back images is determined by the camera's internal clock at the time of shooting. The time when location data is obtained will be recorded on images, but it will not be displayed on the camera. • The location data for the first frame will be recorded on a series of images shot using continuous shooting. B Battery Drain While Recording Location Data and Log Recording • When Record location data is set to On, record location data functions will continue to operate at the specified interval for approximately 6 hours even after the camera is turned off. Also, record location data functions and log recording function will continue to operate during log recording (E42) even after the camera is turned off. • When Record location data is set to On or during log recording, the battery power will drain faster than usual. E40 Reference Section