Onkyo TX-DS676 Owner Manual - Page 18
Setting the speaker configuration - av receiver
View all Onkyo TX-DS676 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Setting the speaker configuration Perform this setup before using the unit. (The layout of buttons, switches, and other controls on the front panel may vary depending where the unit is purchased.) SP/SYS SETUP button SMART SCAN CONTROLLER STANDBY/ON STAND-BY POWER ON OFF A SPEAKERS B PHONES MULTI CH INPUT DIMMER DISPLAY FM MUTE/ MODE DOWN TUNING UP CHARACTER/ MEMORY SP/SYS AUDIO BASS/ SETUP ADJUSTMENT TREBLE MODE PRESET/MODE ADJ SMART SCAN CONTROLLER DIRECT STEREO LISTENING MODE /DTS THX SURROUND PUSH TO ENTER DSP REC OUT DIGITAL/ ANALOG CH LEVEL MODE DVD VIDEO-1 VIDEO-2 VIDEO-3 VIDEO-4 TAPE FM AM PHONO C D DOWN MASTER VOLUME UP VIDEO 4/VIDEO CAM INPUT S VIDEO VIDEO L AUDIO R(MONO) AV RECEIVER TX-DS777 1 SP/SYS SETUP SPEAKERS A TUNED AUTO PRESET/MODE ADJ 2 PUSH TO ENTER PRESET/MODE ADJ PUSH TO ENTER PRESET/MODE ADJ TX-DS777 only SPEAKERS A TUNED AUTO PUSH TO ENTER 3 ~ 6 PRESET/MODE ADJ PUSH TO ENTER PRESET/MODE ADJ 7 PUSH TO ENTER PRESET/MODE ADJ SPEAKERS A Front Center Surround TUNED FM STEREO AUTO 18 PUSH TO ENTER Setting the speaker configuration parameters Using the SMART SCAN CONTROLLER, you can easily set the speaker configuration. Turn it to select the parameter and press it to go to the next item. 1. Press the SP/SYS SETUP button. "Config Setup?" appears. Then Press the SMART SCAN CONTROLLER. 2. For the TX-DS676, go to the next step. For the TX-DS777, "All Ch For THX" appears. Set "Yes" or "No." Yes: Your system is a THX speaker system. (The following steps are unnecessary.) No : Your system is a non-THX speaker system. Press the SMART SCAN CONTROLLER. 3. Set whether or not a subwoofer is connected. Yes: A subwoofer is connected. No: A subwoofer is NOT connected. Press the SMART SCAN CONTROLLER. 4. Select the size of your front speakers. Large: Large front speakers are used. Small: Small front speakers are used. Press the SMART SCAN CONTROLLER. 5. Select the size of your center speaker. Large: A large center speaker is used. Small: A small center speaker is used. None: A center speaker is NOT used. Press the SMART SCAN CONTROLLER. 6. Select the size of your surround speakers. Large: Large surround speakers are used. Small: Small surround speakers are used. None: Surround speakers are NOT used. 7. Press the SMART SCAN CONTROLLER. This completes the speaker configuration setup.