Onkyo TX-DS676 Owner Manual - Page 7

Audio equipment connections 1. DIGITAL INPUT connectors • If your CD player has a digital output connector, connect it to a proper DIGITAL INPUT connector for clear and dynamic sound play. • This unit provides four digital input connectors to connect CD players, MD recorders, DAT decks, etc. having a digital output connector. When using these connectors, connect the unit also via the audio connection cables. You should also note that the signals you can record are analog signals only. • The digital inputs, COAXIAL 1, 2 and OPTICAL 1, 2can be assigned to individual input selector buttons, so when an input selector button is pressed, the assigned digital input is used instead of the corresponding analog input. (See page 23,29.) 2. OPTICAL DIGITAL OUTPUT connector (TX-DS777 only) If you have a digital recorder, such as an MD recorder, DAT, and CD-R (Compact Disc Recorder), connect the recorder's digital input connector to this connector. In this case, always use commercially available optical digital audio cables. 3. Turntable This receiver is designed for use with turntables using moving magnet cartridges. Connect a ground (or earth) wire to GND terminal. With some players, connecting a ground wire results in larger noise. If so, do not connect any ground wire. Optical digital connector Remove the protective caps before making connections. When not in use, be sure to replace them. DIGITAL INPUT R AMP IN COAXIAL 1 COAXIAL 2 OPTICAL 1 FRONT PRE OUT FRONT SUB WOOFER CENTER OPTICAL 2 SURROUND FRONT OPTICAL DIGITAL OUTPUT SUB WOOFER CENTER SURROUND MULTI CHANNEL INPUT R CD GMD PHONO R L L L R L V S VIDEO-1 OUT IN VIDEO-2 VIDEO-3 OUT IN IN ANTENNA AM FM 75 DVD IN (REC) OUT MONITOR OUT AV RECEIVER MODEL NO. TX-DS777 TAPE V S IN (PLAY) R L VIDEO S VIDEO OSD SELECTOR SURROUND SPEAKERS FRONT SPEAKERS A R L R L CENTER SPEAKER CAUTION: SPEAKER IMPEDANCE 6 OHMS MIN. / SPEAKER R L FRONT SPEAKERS B AC OUTLETS AC 120V 60Hz SWITCHED TOTAL 120W 1A MAX. REMOTE CONTROL Worldwide and European models U.S.A. and Canadian models Capacity is total 120 watts. Capacity is total 100 watts. AC outlet connection You can connect the power cord from another audio device to the rear of this receiver. Since the AC outlets on the unit are a SWITCHED type outlet, you can use the STANDBY/ON button, to turn on/off the power to both this receiver and the connected audio devices. First turn the POWER switch ON ( ). The shape, number, and total capacity of the AC outlets may differ depending on the area of purchase. Make sure that the total capacity of other components connected to this unit does not exceed the capacity that is printed on the rear panel. TX-DS777/TX-DS676 DIGITAL INPUT R AMP IN COAXIAL 1 COAXIAL 2 OPTICAL 1 FRONT PRE OUT FRONT SUB WOOFER CENTER OPTICAL 2 SURROUND FRONT OPTICAL DIGITAL OUTPUT SUB WOOFER CENTER SURROUND MULTI CHANNEL INPUT R CD GMD PHONO R L L L R L V S OUT VIDEO-1 IN VIDEO-2 VIDEO-3 OUT IN IN ANTENNA AM FM 75 DVD IN (REC) OUT TAPE MONITOR OUT V S AV RECEIVER MODEL NO. TX-DS777 IN (PLAY) R L VIDEO S VIDEO OSD SELECTOR SURROUND SPEAKERS FRONT SPEAKERS A R L R L CENTER SPEAKER CAUTION: SPEAKER IMPEDANCE 6 OHMS MIN. / SPEAKER R L FRONT SPEAKERS B AC OUTLETS AC 120V 60Hz SWITCHED TOTAL 120W 1A MAX. REMOTE CONTROL CD Player Cassette Tape Deck Connections for remote control (z) You can use the remote controller of this receiver to operate cassette tape decks and compact disc players that have Onkyo z connectors. Connect a remote control cable to the connector with the z mark. • An z remote control cable equipped with a 3.5mm (1/8 in.)-diameter miniature two-conductor phone plug comes with every compact disc player or cassette tape deck that has an z connector. • Remote control operation is not possible if only the remote control cable is connected - the audio connection cables must also be connected. • This receiver's remote controller does not support control of Onkyo turntables. • If the connecting device has two z connectors lined-up vertically or horizontally, you can use either of them. They both offer the same functionality. • You can use the remote controller for the TX-DS777/TXDS676 to control a Onkyo DVD player or MD recorder that is not connected via an z cable. When you control such a DVD player or MD recorder, point the remote controller toward the sensor area of the DVD player or MD recorder. 7