Onkyo TX-DS676 Owner Manual - Page 31

Selecting an input source Remote controller Remote controller SPEAKERS A SLEEP STEREO AUTO BASS/ TREBLE 4 * Tone Control * Bass = 0 Treble = +2 Set To Flat Muting the sound (Muting function, remote controller only) Use this function to turn off the playback sound immediately. For example, you can use it when you receive a phone call when listening to music. Press the MUTING button. The display shows "Muting." Now the sound output to the speakers and headphones stops. Press the MUTING button again to turn on the sound output. Note: The Muting function will be canceled automatically if the receiver is set in the standby mode. Falling asleep with music (Sleep function, remote controller only) You can turn off the power to the TX-DS777/676 automatically after a specified time period. 1. Press the MODE AUDIO button. 2. Press the SLEEP button. The display shows "Sleep 90min," which means the receiver automatically enters the standby mode after 90 minutes. 3. Press the SLEEP button repeatedly until the desired sleep time is displayed. Each time you press this button, the time decreases by 10 minutes. To check how much time is left before the unit turns off... Press the SLEEP button when the Sleep function is enabled. Note: Pressing the SLEEP button when the Sleep time display shows 10 minutes or less cancels the Sleep function. Adjusting the tone (Bass and treble adjustment) The bass and treble levels can be adjusted in the range of +/-12 in units of 2. You cannot perform this adjustment when the listening mode is "THX" or "Direct." 1. Press the BASS/TREBLE button. The display shows "Bass=." Rotate the SMART SCAN CONTROLLER to adjust the bass level. 2. Press the SMART SCAN CONTROLLER. The display shows "Treble=." Rotate the SMART SCAN CONTROLLER to adjust the treble level. 3. Press the SMART SCAN CONTROLLER. • Adjusting the bass and treble levels with the onscreen display 1. Press the OSD MENU button. 2. Select "Listening mode Setup" and then press the right edge of the ENTER/Cursor button. 3. Select "Listening Mode" and then press the right edge of the ENTER/Cursor button 4. Select "Tone Control" and then press the right edge of the ENTER/Cursor button. The "Tone Control Setup" screen appears. Press the upper or lower edge of the ENTER/Cursor button to select "Bass" or "Treble" and then press the right or left edge of the button to adjust the bass or treble level. Select "Set to Flat" and then press the right edge of the ENTER/ Cursor button to restore the "flat" bass and treble sound. 5. Press the center of the ENTER/Cursor button, or press the EXIT button, to exit the setup mode. Note: 31 You cannot perform this adjustment when the listening mode is "Di- rect" or "THX (TX-DS777 only)."