Onkyo TX-SR600 Owner Manual - Page 25

Connections (TX-SR600/600E) Connecting a DVD Player with 5.1-Channel Output ANTENNA FM AM 75 DIGITAL INPUT OPTICAL 2 1 DIGITAL DIGITAL OUTPUT INPUT OPTICAL COAXIAL COMPONENT VIDEO INPUT 2 INPUT 1 OUTPUT Y VIDEO 3 VIDEO 2 VIDEO 1 IN IN OUT IN PB REMOTE CONTROL PR DVD MONITOR IN OUT VIDEO CD IN L SUBWOOFER PRE OUT R TAPE OUT IN S VIDEO IN IN OUT IN FRONT SURR CENTER L L R VIDEO 3 VIDEO 2 VIDEO 1 R DVD SUB WOOFER : Signal flow Y PB Component video output PR Video ouput S video output 3. DVD player (DVD) Analog audio output (center) Analog audio output (subwoofer) L (white) Analog audio output (surround L/R) R (red) L (white) Analog audio output (front L/R) R (red) Digital audio output (coaxial) Connecting your video components Below is an example of how you can connect your video components to the TX-SR600/600E. Refer to the diagram above for the following connection examples. COMPONENT VIDEO INPUT/OUTPUT For DVD players or other devices that have component video connectors, the TX-SR600/600E has two banks of component video input connectors (Y, PB, PR) for direct component video input. The TX-SR600/600E also has one bank of component video output connectors for direct component video output to the matrix decoder of a television, projector, or other display device. By sending the pure component video signal directly, the signal forgoes the extra processing that normally would degrade the image. The result is vastly increased image quality, with incredibly lifelike colors and crisp detail. • The signal that comes in from COMPONENT VIDEO INPUT is only sent to COMPONENT VIDEO OUTPUT. When connecting a video player to the COMPONENT VIDEO INPUT jacks, be sure to connect your television to the COMPONENT VIDEO OUTPUT jacks. VIDEO IN/OUT These are the video inputs and outputs. On the rear panel, there are four video inputs and one video output and each one includes both composite video and S video configurations. Connect VCRs, VTRs, LD players, DVD players, and other video components to the video inputs. Connect VCRs, VTRs, and other recording components to the video outputs to make video recordings. • When connecting a VCR or other video component, make sure you connect its audio and video leads to the same bank (e.g., both to VIDEO 3). • The VIDEO 4 inputs are located on the front panel. The flow of the video signals is as follows: The signal that comes in from a VIDEO IN jack is sent to the VIDEO OUT jack. The signal that comes in from a S VIDEO IN jack is sent to the S VIDEO OUT jack. It is not necessary to make both video and S video connections. Notes: • If your video output device (e.g., television or projector) is connected only to the MONITOR OUT VIDEO jack, MONITOR OUT S VIDEO jack, or both, and the video signal from the source component is input through the component video connectors, no picture will appear. Video sources input from the component video connectors can only be output from the component video connectors. • For more information about the DIGITAL INPUT/OUTPUT jacks, see page 24. 25