Onkyo TX-SR600 Owner Manual - Page 35
Connecting the antenna cable to the 75/300
View all Onkyo TX-SR600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Connecting antennas Connecting an FM outdoor antenna Make sure to follow the general rules given below: • Keep the antenna away from noise sources (neon signs, busy roads, etc.). • It is dangerous to put the antenna close to power lines. Keep it well away from power lines, transformers, etc. • To avoid the risk of lightning and electrical shock, grounding is necessary. Follow item 14 of the "Important Safeguards" on page 2 when you install the outdoor antenna. Directional linkage Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter. To receiver To TV (or VCR) ANTENNA R FM AM PH 75 Connecting the antenna cable to the 75/300 Ω antenna adapter (For all models other than USA & Canadian models and European models) Connecting the 300 Ω ribbon wire: Loosen the screws on the adapter and wrap the wires of the ribbon wire around these screws. Then tighten the screws down with a screwdriver. Connecting an AM outdoor antenna If reception is poor with the indoor AM antenna, stretch out the outdoor antenna (16 feet (5 meters) or more) above a window or outside. • Keep the indoor AM loop antenna connected. Do not remove it. • To avoid the risk of lightning and electrical shock, grounding is necessary. Follow item 14 of the "Important Safeguards" on page 2 when you install the outdoor antenna. Outdoor antenna (Indoor) AM loop antenna ANTENNA FM AM 75 R L PHONO IN DIGITAL INPUT DIGITAL VIDEO 3 VIDEO 2 OUTPUT COAXIAL IN OUT IN O OPTICAL 2 1 OPTICAL Note: If you are using the TX-SR700/700E/600/600E worldwide model in a region where AM frequencies are delineated by 10-kHz steps, be sure to set the "AM Frequency Step" Setup setting accordingly (see page 56). Outdoor antenna 300 Ω ribbon wire Connecting the coaxial cable: 1. With your fingernail, or a small screwdriver, press the stoppers of the 75/300 Ω antenna adapter outward and remove the cover. 2. Remove the transformer wire A from slit B and insert it into slit C. 3. Prepare the coaxial cable as shown in the diagram. 4. Connect the 75/300 Ω antenna adapter to the coaxial cable. 1. Insert the end of the cable. 2. Clamp it in place with pliers. 5. Reinstall the cover. 1 2 3, 4 Slit B ✦ ✦ ✦✦ ✦ ✦ 636 mm mm mm 5/8" (15mm) Wire A Slit C 35