Onkyo TX-SR600 Owner Manual - Page 29
Connections TX-SR700/700E/600/600E - remote code
View all Onkyo TX-SR600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Connections (TX-SR700/700E/600/600E) AC OUTLETS The TX-SR700/700E/600/600E is equipped with AC mains outlets for connecting the power cords from other devices so that their power is supplied through the TX-SR700/700E/600/600E. By doing this, you can leave the connected device turned on and have the STANDBY/ON button on the TX-SR700/700E/600/600E turn on and off the device together with the TX-SR700/700E/600/600E. The shape, number, and total capacity of the AC outlets may differ depending on the area of purchase. Caution: Make sure that the total capacity of the components connected to the TX-SR700/700E/600/600E does not exceed the capacity that is printed on the rear panel (e.g., TOTAL 120W). AC OUTLETS AC OUTLETS AC 120V 60 Hz SWITCHED TOTAL 120W 1 A MAX. AC 230-240V 50 Hz SWITCHED TOTAL 100W MAX. European and some USA and Canadian Asian models models REMOTE CONTROL The terminal on the TX-SR700/700E/600/600E is for connecting other Onkyo components equipped with the same terminal. When a component is connected to the terminal, it can be operated by the remote controller supplied with the TX-SR700/ 700E/600/600E. In addition, when you connect a component to the terminal, you can also perform the system operations given below. Power on/ready function When the TX-SR700/700E/600/600E is in the standby state, if an -connected component is turned on, the TX-SR700/700E/600/ 600E also turns on and the input source selected at the TX-SR700/ 700E/600/600E automatically switches to that component. Be aware that this function will not work if the power cord for the -connected component is connected to the AC OUTLET on the TX-SR700/700E/600/600E, or if the TX-SR700/700E/600/600E has already been turned on. Direct change function When the play button is pressed at an -connected component, the input source selected at the TX-SR700/700E/600/600E automatically changes to that component. Power off function When the TX-SR700/700E/600/600E is placed in the standby state, all -connected components are also automatically put into the standby state. Also, if you press the ON button on the TX-SR700/700E/600/600E remote controller while the TX-SR700/700E/600/600E is turned on, all -connected components (DVD players, CD players, MD recorders, tuners, etc.) are also turned on. Caution: If an MD recorder is connected to the TAPE jack on the TX-SR700/ 700E/600/600E, switch the Input Selector from TAPE to MD (see page 46). TX-SR700/700E/ 600/600E REMOTE CONTROL connector Ex: Onkyo CD player connector Ex: Onkyo cassette tape deck To connect components using the terminal, simply connect a remote control cable from this terminal to the terminal of the other component. An remote control cable with a 1/8-inch (3.5mm) miniature two-conductor plug comes with every cassette tape deck, compact disc player, MD recorder, and DVD player that has an terminal. • When performing operations with -connected components using the system, do not use the remote zone (Zone 2) (TXSR700/700E only). • For remote control operation, the audio connection cables must also be connected. • If a component has two terminals, you can use either one to connect to the TX-SR700/700E/600/600E. The other one can be used to daisy chain with another component. • With Onkyo DVD players, you can enter the pre-program code so that you can operate the DVD player directly with the remote controller without connecting the terminals (see page 67). 29