Pioneer PDP-6020FD Owner's Manual - Page 20
The bottom screw hole on each, speaker bracket is not used when, the panel remains on the stand. - pdp speakers
UPC - 012562887104
View all Pioneer PDP-6020FD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
02 Install Your Flat Panel TV 6 ) Attach the speaker to the side brackets using the supplied screws. . ➂ ➀ Speaker mounting screw (M5 x 10 mm) The bottom screw hole on each speaker bracket is not used when the panel remains on the stand. ➁ Note: If the speaker needs to be repositioned (horizontally or vertically) after it is attached, loosen the speaker mounting screws first. Adjust the position then retighten the screws. 2.2.2 Connect the Speaker Cables 1 ) Press down on the tab. 2 ) Insert the appropriately colored wire into the opening. 3 ) Allow a small percentage of the cable's bare wire to remain visible. 4 ) Release the tab to clamp the wire. If the bare wire is hidden when the tab is released, repeat Steps 1 through 4 until the proper amount of cable is showing. 5 ) Repeat this process for each cable, matching the color of the wire to the appropriate terminal. 6 ) Connect the speaker cables to the speaker. 7 ) Bundle the speaker cables, power cord and other cables in the cable clamp then insert the clamp into an appropriate hole on the rear of the flat panel TV. Refer to "2.6 Route then Bundle the Power Cord and Cables." Use the clamps as necessary (see page 30). Gray Black tab Gray Speaker terminal Red Black Red (PDP-6020FD) Speaker cable 20 En