Pioneer PDP-6020FD Owner's Manual - Page 70

05 Use Other Equipment With Your Flat Panel TV 5.1.3 Clear Added Manufacturer Codes from the Remote Control To return all learned and preset codes to the defaults (PIONEER), follow the steps below. 1 ) Press EDIT and TV  at the same time. Selection can be in any mode. 2 ) Press the Yellow button. Confirm that the selected mode indicator flashes. The remote control enters the Manufacturing Reset mode. The reset is complete when the mode indicator flashes on for one second. The remote control then returns to normal operation. Note: The panel's remote control may not control or have complete control of some equipment listed in the tables. To exit before the reset is complete, press the EDIT button again. The reset is cancelled if no action is taken within 60 seconds. Also, switching the Mode during this procedure cancels the reset. 5.1.4 Control a Pioneer Receiver The flat panel TV's remote control has a bank of buttons specifically for controlling a Pioneer receiver. The active buttons, left to right, are as follows: • RECEIVER STANDBY/ON (turns the Pioneer Receiver On/Off) • RECEIVER INPUT (cycles through/selects an input) • RECEIVER VOL - (adjusts the volume lower) • RECEIVER VOL + (adjusts the volume higher) 70 En