Ricoh P 311 Users Guide - Page 188

8. Configuring Network Settings Connecting the Machine to a Wireless Network • To use wireless network, the wireless LAN option needs to be installed to the machine. There are four methods for connecting the machine to a wireless network: • Using the Wi-Fi Setup Wizard See page 186 "Using the Wi-Fi Setup Wizard". • Using the WPS button See page 187 "Using the WPS Button". • Using a PIN code See page 188 "Using a PIN Code". Using the Wi-Fi Setup Wizard A router (access point) is needed to set up a connection. Checking the SSID and encryption key The SSID and Encryption key for the router (access point) may be printed on a label affixed to the router (access point). For details about the SSID and Encryption key, refer to the router (access point) manual. Configuring settings using the control panel Make sure the Ethernet cable is not connected to the machine 1. Check that the router (access point) is working correctly. 2. Make sure the wireless LAN option is attached to the machine and the wireless (Wi-Fi) connection is enabled. 3. Press the [Menu] key. 4. Press the [ ] or [ ] key to select [Network Wizard], and then press the [OK] key. 5. Enter the administrator password. 6. Press the [ ] or [ ] key to select [Wireless (Wi-Fi)], and then press the [OK] key. 7. Press the [ ] or [ ] key to select SSID of the router (access point) from the searched SSID list, and then press the [OK] key. 8. Press the [Menu] key to enter the character-selection mode, and select a character of the encryption key using the or [ ] key, and press the [OK] Key. When you finish entering the encryption key, press the [OK] key. As the passphrase, you can enter either 8 to 63 ASCII characters (0x20-0x7e) or 64 hexadecimal digits (0-9, A-F, a-f). 186