Ryobi GD201 Operation Manual - Page 25
Mounting The Power Head To The, Ceiling
![]() |
View all Ryobi GD201 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
INSTALLATION MOUNTING THE POWER HEAD TO THE CEILING See Figures 33 - 38. WARNING: Mount garage door opener to sound structural support on ceiling. NEVER mount the garage door to drywall or false ceiling grids. ALWAYS use concrete anchors when installing brackets into concrete, brick, or other masonry. Failure to properly mount the power head can cause it to fall and could result in death, serious personal injury, or property damage. Locate the following items: Mounting Strap (2) Bolt (M6 x 3/4 in.) [6] Washer (M6) [6] Nut (M6) [6] Lower the garage door completely. Measure the space between the header bracket and the ceiling. NOTE: For unfinished ceilings, measure the space between the header bracket and the nearest joists on either side. Carefully lift the power head and place it on top of a ladder. Move the power head until it is aligned with the header bracket and the rail assembly is over the center line of the door. Pull the trolley release lever down and slide outer trolley completely toward the power head. NOTE: The proper configuration and placement of brackets and mounting straps will vary based on the design and construction of your garage ceiling. Figures 34 - 38 are meant to serve as examples but your setup may vary. Measured Distance Header Bracket Ceiling Power Head Outer Trolley 25 - English Fig. 33
![](/manual_guide/products/ryobi-gd201-operation-manual-4b876a2/25.png)