Ryobi GD201 Operation Manual - Page 42

OPERATION NOTICE: Do not open or close the garage door using the indoor keypad or remotes until the travel limits have been properly set. Doing so could cause severe damage to the garage door or the garage door opener. Before setting the travel limit:  Pull the emergency release rope down and manually open the garage door until the outer trolley engages the inner trolley. Once you begin setting the travel limits, you have two minutes to complete each step. If a step is not completed within two minutes, travel limit information for the open and closed position will be erased. To set the travel limit for the open position:  Open the console door.  Press and hold the UP button for three seconds. After you release the button, it will begin blinking and continue blinking until the travel limit has been set.  Press and hold the UP button to move the garage door to the open position.  For fine adjustments, press and release the UP or DOWN buttons.  Once the door is in the open position, press the SET button to store the travel limit. Once the travel limit is stored, the UP button will stop blinking and shine continuously. NOTE: If the safety sensors are obstructed during this process, travel limit information for the open and closed position will be erased. Correct (Fully Open Position) Incorrect (Fully Open Position) Outer Trolley Inner Trolley Inner Trolley Outer Trolley Fig. 75 Release Lever Fig. 76 42 - English