Ryobi GD201 Operation Manual - Page 52

TROUBLESHOOTING PROBLEM Garage door cannot be opened or closed with car remote or outdoor keypad Garage door opener is loud or noisy AC modules not working DC modules not working Outdoor keypad does not work. Car remote not working Opener can't connect to Wi-Fi network POSSIBLE CAUSE The garage door opener is in Vacation Mode. Fasteners may not be tightened securely The open travel limit has been set incorrectly (Single Panel Doors Only) AC power supply is disconnected GFCI is tripped One or two modules are installed with a combined rating of more than 10 amps AC power supply is disconnected The port powering the DC module is not activated. Keypad not programmed correctly The keypad's signal is obstructed RF antenna is obstructed Remote not programmed correctly The remote's signal is obstructed Wi-Fi router is not connected to the internet Opener not programmed correctly Wi-Fi router using WEP security scheme SOLUTION Press the LOCK ( ) button on the indoor keypad or smart phone app to unlock the garage door opener Inspect the entire product for loose parts such as screws, nuts, bolts, caps, etc. Tighten all parts securely Adjust the travel limits as described in the Operation section Connect AC power supply Press the reset button on the console Remove the module or modules and press the 10 amp circuit breaker reset button on the console. Connect AC power supply Use the indoor keypad to activate the port. Program the keypad as described in the Operation section Move keypad to a different location Position the antenna below the opener. Program the remote as described in the Operation section Move remote to a different location Connect Wi-Fi router to the internet Program unit according to app instructions Change your network security settings to WPA/WPA2 52 - English