Ryobi GD201 Operation Manual - Page 43

OPERATION To set the travel limit for the closed position:  Press and hold the DOWN button for three seconds. After you release the button, it will begin blinking and continue blinking until the travel limit has been set.  Press and hold the DOWN button to move the garage door to the closed position.  For fine adjustments, press and release the UP or DOWN buttons.  Once the door is in the closed position, press the SET button to program the travel limit. Once the travel limit is set, the DOWN button will stop blinking and shine continuously. NOTE: If the safety sensors are obstructed during this process, travel limit information for the open and closed position will be erased. To test the travel limits: NOTE: The garage door opener will not respond to the remotes or keypads until the travel limits have been tested.  Press and release the UP button and ensure that the door moves to the programmed open position. The button will blink as the door moves then shine continuously once the door is in the open position.  Press and release the DOWN button to ensure that the door moves to the programmed down position. The button will blink as the door moves then shine continuously once the door is in the down position. NOTE: After testing is complete, the light for both the UP and DOWN buttons will turn off.  If the travel limits were set incorrectly, they can be cleared by pressing and holding the UP button for three seconds. If a buzzer sounds while you are setting or testing the travel limits, the garage door opener has detected a problem. Travel limit information for the open and closed position will be erased and cannot be reset until the problem is resolved. For details, refer to the Troubleshooting section later in the manual. Set Down Up Console Door Fig. 77 Fig. 78 43 - English