Schwinn 810 Treadmill Service Manual - Page 104
Slide the Rear Roller out of the Walking Belt.
![]() |
View all Schwinn 810 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
12. Using a 6mm hex wrench, remove both of the Adjustment Bolts from the Rear Roller. Note: Be sure to record the number of turns of the Adjustment Bolt it takes to remove it. This will assist with reassembly. 13. Slide the Rear Roller out of the Walking Belt. 14. Slide the new Rear Roller into the new Walking Belt in the same orientation. 15. Using a 6mm hex wrench, re-attach the Adjustment Bolt to the Rear Roller. Note: Be sure to tighten the Adjustment Bolt the same number of turns it took to loosen the Walking Belt. 16. Re-install all remaining parts that were removed in reverse order. 17. Final Inspection Inspect your machine to ensure that all hardware is tight and components are properly assembled. Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's Manual. Rear Roller Adjustment Bolt 104
![](/manual_guide/products/schwinn-810-treadmill-service-manual-1818dc8/104.png)