Schwinn 810 Treadmill Service Manual - Page 68
Belt, or near the Treadmill.
![]() |
View all Schwinn 810 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
13. Make sure there is no object on or around the treadmill to spill or cause blockage from the fully unfolded position. 14. Slightly push the walking deck forward toward the console. With your foot lightly push the top part of the hydraulic lift forward until the locking tube releases and you can pull the walking deck away from the console. Hold up the rear of the walking deck, and move to the side of the machine. Keep clear of the movement path of the walking deck. 15. The hydraulic lift is set up to drop gradually. Hold onto the walking deck until approximately 2/3 of the movement down. Lower the weight with your legs. Be aware that the walking deck can possibly drop quickly in the last part of the movement. 16. Re-install all remaining parts that were removed in reverse order. 17. Attach the power cord and turn on the Treadmill by flipping the power switch to ON. 18. Stand next to the machine where the Console can easily be reached. Be sure the area around the Treadmill is clear of all bystanders, children and pets. Be sure there is nothing on or under the Walking Belt, or near the Treadmill. 19. Push and hold down the Pause/Stop and Enter buttons until machine enters engineering mode. 20. Push the Start button 8 times. 21. The calibration procedure will begin by automatically moving the Walking Belt and adjusting the incline of the Walking Deck for about a minute. Then the console will flash and beep. Be sure not to touch or allow anyone else to touch the machine while calibration is occurring. USER MANUAL HR ZONES Max 100% Anaerobic 80-90% Aerobic 70-80% MANUAL GOALS WEIGHT LOSS INTERVALS HEART RATE CUSTOM Fat Burn 50-70% Warm Up 50% GOALS PROGRAMS WEIGHT LOSS INTERVALS HEART RATE CUSTOM 10 8 6 4 2 Enter button 22. The calibration procedure is now complete. Start button Pause/Stop button 23. Final Inspection Inspect your machine to ensure that all hardware is tight and components are properly assembled. Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's Manual. 68
![](/manual_guide/products/schwinn-810-treadmill-service-manual-1818dc8/68.png)