Schwinn 810 Treadmill Service Manual - Page 85
Drive Pulley.
![]() |
View all Schwinn 810 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
20. Loop the Drive Belt around the Front Roller. Insert the end of the Front Roller with the Drive Pulley into the Frame and pivot the other end into the Bracket. 21. Using a 6mm hex wrench, attach the Front Roller to the Bracket. Note: Tighten the hardware until the Front Roller is centered in the Bracket. Bracket Front Roller 22. Loop the Drive Belt around the Motor Pulley. Start the Drive Belt on the Drive Pulley and roll it in a clockwise motion. Be sure the Belt does not come off of the Motor Pulley. Keep fingers out of any pinch opportunities when turning the Pulleys. 23. Roll the Drive Pulley clockwise until the Drive Belt is fully installed. Continue to roll the Belt forward while adding side pressure with fingers to align as necessary. 24. Fully tighten the hardware that secures the Motor to the Frame. 25. Inspect the Speed Sensor to see if it has been moved during the procedure. If necessary, adjust it to be the appropriate distance from the Drive Pulley. 26. Re-install all remaining parts that were removed in reverse order. Speed Sensor Assembly Drive Pulley Motor Pulley 85
![](/manual_guide/products/schwinn-810-treadmill-service-manual-1818dc8/85.png)