Schwinn 810 Treadmill Service Manual - Page 51
Loop the Drive Belt around the Motor Pulley. Start the Drive Belt
![]() |
View all Schwinn 810 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Note: Your machine may not match the provided images exactly. 14. Lift and pivot the Front Roller out of the Frame, and slide it out of the Walking Belt. This will free the Drive Belt from the Front Roller. 15. Loop the new Drive Belt around the Front Roller. Insert the end of the Front Roller with the Drive Pulley into the Frame and pivot the other end into the Bracket. 16. Using a 6mm hex wrench, attach the Front Roller to the Bracket. Note: Tighten the hardware until the Front Roller is centered in the Bracket. Bracket Front Roller 17. Loop the Drive Belt around the Motor Pulley. Start the Drive Belt on the Drive Pulley and roll it in a clockwise motion. Be sure the Belt does not come off of the Motor Pulley. Keep fingers out of any pinch opportunities when turning the Pulleys. 18. Roll the Drive Pulley clockwise until the Drive Belt is fully installed. Continue to roll the Belt forward while adding side pressure with fingers to align as necessary. 19. Inspect the Speed Sensor to see if it has been moved during the procedure. If necessary, adjust it to be the appropriate distance from the Drive Pulley. 51 Speed Sensor Assembly Drive Pulley Motor Pulley
![](/manual_guide/products/schwinn-810-treadmill-service-manual-1818dc8/51.png)