Sharp MX-6500N Adjustment Guide - Page 20

2.2.2 Scan Original Edge Adjustment (Duplex Single Pass Feeder) This performs edge (scanning start) position adjustment for scanning original from document feeder. 1) Select [Scan Original Edge Adjustment (Duplex Single Pass Feeder)] in the Edge Adjustment screen. Specify the Print Position Adjustment first. 2) Enter the desired values and tap the [Register] key. 2) Enter the desired values and tap the [Register] key. Input range: [20] to [80] (1 = 0.1 mm) Default: [50] for each Note: To return your preferences to the factory defaults, tap the [Return Original Scan Edge Adjustment Value (Duplex Single Pass Feeder) to Default] key. When a confirmation message appears, tap the [OK] key. Your preferences are returned to the factory defaults and the screen returns to the Edge Adjustment screen. 2.3 Void Area Adjustment Select [Void Area Adjustment] in the Image Position/Ratio/Area Adjustment screen. 2.3.1 Copy Image Loss Amount Settings This performs adjustment of image loss amount for scanning original in copy mode. 1) Select [Copy Image Loss Amount Settings] in the Void Area Adjustment screen. Specify the Print Position Adjustment first. Input range: [0] to [99] (1 = 0.1 mm) Defaults: Edge image loss amount setting: [40] Side image loss amount setting: [20] Note: To return your preferences to the factory defaults, tap the [Return Copy Image Loss Amount Settings to the Default] key. When a confirmation message appears, tap the [OK] key. Your preferences are returned to the factory defaults and the screen returns to the Void Area Adjustment screen. 2.3.2 Print Void Settings This performs adjustment of print void amount for printing. 1) Select [Print Void Settings] in the Void Area Adjustment screen. 2) Enter the desired values and tap the [Register] key. Input range: [0] to [99] (1 = 0.1 mm) Defaults: Print Lead Edge Void Amount Adjustment: [40] to [99] Print Rear Edge Void Amount Adjustment: [30] to [99] FRONT/REAR Void Amount Adjustment: [20] 20