Sharp MX-6500N Adjustment Guide - Page 23

3 Peripheral Adjustment Select [Peripheral Adjustment] in the Machine Adjustment screen. Adjustable options: The saddle finisher, trimming module, finisher, punch module, and folding unit can be adjusted: The installed options are displayed as follows:  When the100-sheet saddle finisher, trimming module and punch module are installed: 3.1 Saddle Finisher (When the 100-sheet saddle finisher is installed) 3.1.1 Staple Position Adjustment This performs staple position adjustment in the direction of paper width. 1) Select [Staple Position Adjustment] in the Saddle Finisher screen. 2) Adjust the staple positions in the direction of paper width. The 10-key pad appears when each of the textboxes is tapped. Enter the desired values. Input range: One staple: [70]-[130] Two staples: [85]-[115] (1 = 0.1 mm) Default: 100 for each Note: Staple position in paper feed direction cannot be adjusted. Functional restriction For 2 staples, the staple positions that can be adjusted vary depending on the paper size and the number of sheets included in a set to be stapled as the following table shows: Paper size A4R/Letter R or smaller Larger than A4R/Letter R Number of sheets included in a set 20 sheets or less More than 20 sheets - Staple position that can be adjusted Only the staple at back Both staples at front and back Both staples at front and back 3.1.2 Paper Alignment Width Adjustment for Staple Position This performs jogger width adjustment for staple (paper width direction). Set this adjustment when the stapled stuck of paper is not aligned. 1) Select [Paper Alignment Width Adjustment for Staple Position] in the Saddle Finisher screen. 2) Adjust the distance between the alignment plates in the direction of paper width for stapling. The 10-key pad appears when the textbox is tapped. Enter the desired value. 23