Sharp MX-6500N Adjustment Guide - Page 25
Trimming Module, Finisher When the 100-sheet finisher is, installed
View all Sharp MX-6500N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Input range: [80] to [120] (1 = 0.20944 mm) Default: [100] 3.2 Trimming Module Select [Trimming Module] in the Peripheral Adjustment screen. 3.2.1 Trimming Original Point Adjustment This performs adjustment of trimming origin position for saddle stitch (fold and staple). This corrects deviation of the actual cutting amount from the amount set with the trimming setting. 1) Select [Trimming Original Point Adjustment] in the Trimming Module screen. 3.3 Finisher (When the 100-sheet finisher is installed) Select [Finisher] in the Peripheral Adjustment screen. 3.3.1 Staple Position Adjustment This performs staple position adjustment for staple in the direction of paper width. 1) Select [Staple Position Adjustment] in the Finisher screen. 2) Adjust the staple positions in the direction of paper width. The 10-key pad appears when each of the textboxes is tapped. Enter the desired values. 2) Adjust the trimming original point for saddle stitching. The 10-key pad appears when each of the textboxes is tapped. Enter the desired values. Input range: One staple: [70]-[130] (1 = 0.1 mm) Two staples: [85]-[115] (1 = 0.1 mm) Default: [100] for each Note: Staple position in paper feed direction cannot be adjusted. Functional Restriction For 2 staples, the staple positions that can be adjusted vary depending on the paper size and the number of sheets included in a set to be stapled as the following table shows: Input range: [50] to [150] (1 = 0.1 mm) Default: [100] for each Paper size A4R/Letter R or smaller Larger than A4R/Letter R 25 Number of sheets included in a set 20 sheets or less More than 20 sheets - Staple position that can be adjusted Only the staple at back Both staples at front and back Both staples at front and back