Sony DVWM2000 Product Manual (dvwm2000 installation manual) - Page 27

1-10. Switch Settings on Circuit Boards 1-11. Operation Mode Settings (For DVW-2000/M2000 Only) 1-10-5. VN-13 Board (MSW-M2000E/ M2000EP/M2100E/M2100EP only) 1-11-1. Operation Procedure of Destination Selection Mode For switch settings on the VN-13 board, refer to "1-1-5. Switch Setting and Function of LEDs on VN-13 Board" in the BKMW-E3000 Installation Manual. 1-11. Operation Mode Settings (For DVW2000/M2000 Only) When turning on the POWER switch for the first time or after executing "M49: RESET ALL SETUP" in the maintenance mode, the mode for selecting a destination (J or SYL) appears. Select a destination following the operation procedure of the destination selection mode. Once a destination is selected, this mode does not appear when the POWER switch is turned on and the unit operates with the selected destination. m . Be sure to select a destination before use. If no destination is selected, the unit will not perform the playback and recording operations correctly even though these operations are enabled. . Destination: "J" is for the models for Japan, and "SYL" is for the models for the countries other than Japan. 1. When no destination has not been selected, turning on the POWER switch displays the following indication in the menu display area of the control panel. DESTINATION SEL - NO-SET SELECT SET F1 F2 F3 F4 F5 F6 2. Press the F2 (SELECT) button. . Pressing the F2 (SELECT) button blinks "NO-SET". . Pressing the F3 (_) or F4 (+) button selects the destination SYL or J. . Pressing the F1 (RETURN) button returns the indication to the original indication shown in step 1. DESTINATION SEL - NO-SET RETURN _ + SET F1 F2 F3 F4 F5 F6 When "SYL" is selected as a destination ("SYL" blinks) DESTINATION SEL - SYL RETURN _ + SET F1 F2 F3 F4 F5 F6 When "J" is selected as a destination ("J" blinks) DESTINATION SEL - J RETURN _ + SET F1 F2 F3 F4 F5 F6 3. Press the F5 (SET) button. . Pressing the F5 (SET) button accepts the selected destination. . When the message "TURN OFF/ON POWER!!" appears, turn off the POWER switch. TURN OFF/ON POWER !! SET F1 F2 F3 F4 F5 F6 To return the destination to the "NO-SET" status: Reset all the unit settings to the factory settings using "M49: RESET ALL SETUP" of the maintenance mode. For details about the maintenance mode, refer to Section 3 in the Maintenance Manual Volume-1. n All the settings, including the setup menu, are reset. HDW-2000/M2000/M2000P/S2000/S2000P/M2100/M2100P, DVW-2000/2000P/M2000/M2000P MSW-2000/A2000/A2000P/M2000/M2000P/M2000E/M2000EP/M2100/M2100P/M2100E/M2100EP 1-21