Sony DVWM2000 Product Manual (dvwm2000 installation manual) - Page 36

1-17. Taking Out the Cassette in Tape Slacking 1-17. Taking Out the Cassette in Tape Slacking When slacking the tape in this unit, follow the steps below to take out the cassette tape. n Being careful not to damage the tape, take out the cassette tape with care. 1. Turn off the power. 2. Fully loosen the fixing screw. 3. Slide the knobs on upper lid (front) assembly each in the inside. (Move the knobs to the outside to fix the upper lid (front) assembly. 4. Remove the upper lid (front) assembly. Knob Upper lid (front) assembly 5. Release the lock of the board holder and open the AE31 board in the arrow direction. (As for MSW-2000, skip this step because the AE-31 board is not used.) 6. Check by eye that the unit is in the state to be able to wind manually the tape. 7. Pull the ME wire for a few times with short steps to take up the tape inside the cassette. m . Be careful for the tape not to catch in parts such as a flange of a tape guide. . Don't take the ME wire off the wire holder. . The ME wire links with the T real table. The T real table rotates about 1/24 turns clockwise (takeup direction) by pulling the ME wire about 6 mm. 8. Rotate the M gear of the threading motor block in direction of arrow shown in the EJECT label by about a half turn to slack off the tape. 9. Pull the ME wire for a few times with short steps in the direction of arrow shown in the EJECT label to take up the tape inside the cassette. Fixing screw Knob AE-31 board Board holder 1-30 Removal Installation M gear EJECT label ME wire EJECT label Wire holder Gear box assembly HDW-2000/M2000/M2000P/S2000/S2000P/M2100/M2100P, DVW-2000/2000P/M2000/M2000P MSW-2000/A2000/A2000P/M2000/M2000P/M2000E/M2000EP/M2100/M2100P/M2100E/M2100EP