Sony DVWM2000 Product Manual (dvwm2000 installation manual) - Page 30

1-13. Switching Search Dial Mode 1-13. Switching Search Dial Mode There are two kinds of operation to switch the mode of the search dial on the lower control panel. . Button selecting To enter the shuttle mode, press the SHUTTLE button. To enter the jog mode, press the JOG button. To enter the variable mode, press the VAR button. . Search dial pressing When you press the search dial, the search dial mode switches in order to shuttle, jog, variable. It is possible to prohibit a manner of switching. Prohibiting Search Dial Pressing 1. After pressing the unlock buttons, open the lower control panel as shown in the figure below. 2. Loosen a screw on the backside of the search dial as shown in the figure. n If it is difficult to loosen the screw, remove the lower control panel unit in advance. (Refer to Section 1-12.) 3. Slide the mode selection plate in the direction indicated by the arrow until it contacts the portion A. Unlock button Unlock button 4. Check to see that the shaft of the search dial is not seen in the round hole of the mode selection plate, and then tighten the screw. Back view Mode selection plate Screw Round hole The shaft is not seen. Allowing Search Dial Pressing 1. Open the lower control panel. (Operation side up) 2. Loosen a screw on the backside of the search dial as shown in the figure. 3. Fully slide the mode selection plate in the direction indicated by the arrow. 4. Check to see that the shaft of the search dial is seen in the round hole of the mode selection plate, and then tighten the screw. Back view Mode selection plate Lower control panel unit Back view Mode selection plate Screw Screw Search dial Portion A Search dial shaft Round hole The shaft is seen. 1-24 HDW-2000/M2000/M2000P/S2000/S2000P/M2100/M2100P, DVW-2000/2000P/M2000/M2000P MSW-2000/A2000/A2000P/M2000/M2000P/M2000E/M2000EP/M2100/M2100P/M2100E/M2100EP