TRENDnet TEW-828DRU User's Guide - Page 40
Access Control (IP Protocol Filter), Protocol/IP Filter, LAN IP Address Range
View all TRENDnet TEW-828DRU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
TRENDnet User's Guide Access Control (IP Protocol Filter) Advanced > Security > Access Control You may want to block computers or devices on your network access to specific ports (used or required by a specific application) to the Internet. Protocol/IP Filter Basic > Parental Control Every network device must be assigned or configured with a specific 32-bit IP address in order to communicate with your network which is typically assigned by your router DHCP server automatically. Using access rules, you can deny specific computers and other devices from using this router's wired or wireless network by specifying the IP address. 1. Log into your router management page (see "Access your router management page" on page 9). 2. Click on Basic, click on Parental Control. 3. Under Access Control, click the LAN Client Filter Function drop-down list and select Enabled to activate the feature. 4. Enable - Check this option to enable the access control rule. 5. LAN IP Address Range: Enter the IP address or IP address range to apply the protocol/IP filter. (e.g. 192.168.10.20-192.168.10.20 or 192.168.10.20-192.168.10.30). Note: The filter will not be applied to IP addresses outside of the range specified. 6. Protocol - Select the protocol type to filter. TCP, UDP. TEW-828DRU 7. Destination Port Range: Enter the port number or range of port numbers to apply in the firewall rule. (e.g. 80-80 or 20-21). For all ports, use the port range 1 - 65534. Note: Clicking Cancel will discard your settings and clear all fields. Schedule: The schedule function allows you to define a schedule when the wireless should be turned on. To define a new schedule, click Add New and refer to page 36 " Create Schedules". After you have created a new schedule, you will be returned to the page to apply the new schedule. If you encounter issues, click the drop-down list and the new schedule will be available for selection. Note: Before applying scheduling, please ensure your Time settings are configured correct and you have defined a schedule. See page 35 to configure Time Settings and see page 36 " Create Schedules" to create a schedule. 8. Click Add to add the access rule to the LAN Client Filter Rules List. Note: In the IP Filter Rules List, you can edit a rule by clicking Edit in the Edit column next to the rule you would like to edit. You can also delete a rule by clicking Remove under the Remove column next to the rule you would like to delete. 9. Repeat steps 4 - 8 for any to block any additional IP addresses and protocols/ports. When finished, click Apply at the bottom of the page to save your settings. © Copyright 2015 TRENDnet. All Rights Reserved. 37