Toshiba SD-H400-S-TU Installation Guide - Page 66
C_h_a_p_t_e_f_5, Channel Change IR
View all Toshiba SD-H400-S-TU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
_ _ _ _C_h_a_p_t_e_f_5 _ I accidentally changed channels with my TV or VCR's remote control. • If you use your TV's or VCR's remote to change the channel, the TV will no longer display the video signal from the SD-H400. To return to viewing video from the SDH400, return to the channel that your TV or VCR was tuned to. You may also need to press the Input, Source, or TVNideo button on your TV's remote to change the input (i.e., the video signal your TV is displaying). I can't get the channel to change. If you have cable without a cable box: • Be sure that you are using the SD-H400's remote and that you hold it so that the TiVo button points toward the SD-H400. Press any button on the remote. Make sure that the batteries are positioned correctly in the remote. If they are correctly positioned, try a new set of batteries. • You may not have the correct input selected on your TV. Use the "Input," "Source," "Select," or "TVNideo" button on your TV's remote to change the input. If you are passing the signal through your VCR (as in Setup 4 in this guide), you may need to select the correct input on the VCR as well. If you have a cable or satellite box and used the IR Control cable: Make sure the cable or satellite box is turned on. • Make sure you are using the SD-H400's remote control, and that you hold it so that the TiVo button points toward the SD-H400, not at the cable or satellite box. • Refer to page 14 to verify that the IR Control cable is positioned correctly in front of the IR sensor. Also, make sure that the purple end of the cable is plugged into the Channel Change (IR) jack on the back of the SD-H400. 52