Toshiba SD-H400-S-TU Installation Guide - Page 67
Settings, then Channels, then Channel Changing, then IR cable. Verify the IR code, Setup
View all Toshiba SD-H400-S-TU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
( Troubleshooting • You may consider optimizing the IR Control connection as described on page 14. Press the TiVo button to go to riVo Central, then select Messages & Setup, then Settings, then Channels, then Channel Changing, then IR cable. Verify the IR code you chose during Guided Setup. See page 14 for more on choosing an IR code. Try using the cable or satellite box's remote to change the channel. Ifit doesn't work, contact the manufacturer or service provider for assistance. If you have a satellite box and used the Serial Control cable: • Make sure the satellite box is turned on. • Verify that the Serial Control cable is plugged into the data connector on the satellite box and into the Channel Change-Serial connector on the back of the SD-H400. • Unplug the satellite box from the wall, then plug it back in. Then try changing channels with the riVo remote again. Try using the cable or satellite box's remote to change the channel. If it doesn't work, contact the manufacturer or service provider for assistance. You may have incorrectly specified the type of program guide for your DlRECTV satellite receiver. There are two types of program guides: MPG (Master Program Guide) and APG (Advanced Program Guide). First, unplug the power cord for the satellite receiver and plug it back in. Next, go to TiVo Central, then Messages & Setup, then Settings, then Channels, then Channel Changing. On the Satellite Channel Changing screen, if you originally selected Serial-MPG, change your selection to Serial-APG. (If you originally selected Serial-APG, change it to Serial-MPG.) You can also check the manual for your satellite receiver (as well as the satellite receiver's system setup screen) for information on the type of program guide it uses. 53